Outside Paly Area
Sunday, December 18, 2011
Tuesday, November 22, 2011
Monday, September 19, 2011
Thursday, September 15, 2011
Thursday, July 21, 2011
Card Board Flash Card Computer Monitor.
Draw a base and then draw a circle in the middle and cut them out.
You cut slits on one side of the paper towel tube.
Slide the tube through the hole.
Glue felt to card
Staple the card board with the felt glued to on the paper towel tube
Staple the piece of Laminating sheet to the front of the board..
Tape all around the monitor with the masking tape.Paint and let dry and you will be ready to add flash cards.
Saturday, July 2, 2011
Tuesday, June 21, 2011
Saturday, June 11, 2011
Saturday, May 14, 2011
How to make a Graduation Hat.
This is what you will need.
Two square pieces of construction paper any color you would like, (8x8 inches).
One piece of card board
(I Use cereal boxes), also 8x8 inches long.
Two strips of the same color construction paper three inches thick and as much as you need to go around the Childs head. Three small pieces of construction paper one inch by two inches use them to connect the piece that fits around the Childs head to the center of the square.
Cut a small hole in the center of the hat to put the gold pen, to hold the tassel on.
Then you take the yarn and wrap it around your hand ten time lay on table and cute a separate piece of yarn about two feet long. Then you Tie the piece of yarn in the middle.
Cute each end and you have a tassel. Then tie the other end to the gold pin in the center if the hat. Write the year and you have a wonderful graduation hat.
.
Subscribe to:
Posts (Atom)